Sling lengths for moving mazak QT 30, 28, 25, 20 etc... are they equal?
We are moving shops and I have 6 machines to move. We're loading them with a fork lift on this end and unloading with an overhead crane on the other. My question is are all 3 slings equal in length? Or...
View Articlemazak sqt10ms capabilities
I have a project that I have to cut an octagon on the end of 1/2” round brass stock. Is the sqt10ms capable of doing this? Thanks Tim Meyer
View ArticleClik here to view.
Clone HDD Mazak Fusion 640T
Hello I try to clone the original HDD and I don't succeed I tried several time to clone the HDD with EaseUs and AOMEI software but with no luck, I am using and IDE 44 pin - Sata adaptor for an old...
View ArticleFusion 640 Integrex Polar Coordinate Interpolation Issues
Hey guys, long-time reader, first-time poster here. I bought a 2001 Mazak Integrex 100-IISY, and I'm now ready to get it running but cannot seem to get around a huge issue with the G12.1 - polar...
View ArticleClik here to view.
Matrix Nexus - How to Program a Multifeed Bar feeder?
Hello. We have a Multifeed MX-1B with our QT Nexus 250-II MS. I've managed to manually move the pushrod, cross slide, etc. The bar feeder itself seems fine. The thing is when I call the bar feeder with...
View ArticleT plus control programming radial grease groove in OD.
Looking for some help programming a radial grease groove. I think i have most of the bugs worked out but now i am getting a 638 Illegal designated tool width alarm. I am using a .078 wide grooving tool...
View ArticleMplus Control trying to use EIA/ISO diameter offsets with Mazatrol tool...
So I have a Mplus control that I have been using the Tool Data for both my diameters and length offsets reliably in EIA/ISO mode. However, because of the limitations of Tool Data, I'm unable to use...
View ArticleClik here to view.
Programming T3 EIA/ISO
Hi. I have an issue with creating a postprocessor for milling text on a T3 with EIA/ISO option. I am not able to do straight lines. If I create a program like this: G0 X100 Z2 C0 G1 Z-0,1 G1 X100 C90...
View ArticleAdvice: Used Variaxis i600 Matrix 2 vs New CV5-500 Smooth X
My fellow comrades and I are about to pull the trigger on a 5 axis mill for toolroom use. Sounds overkill, but it's not if you've seen our modular tooling system. Having been through the options we're...
View ArticleClik here to view.
Mazak QT15n - problem with chuck
Hello, I have a problem with my machine. I can't open and close chuck from the program (If I do it manually, everything works fine). As for the sensors, they are pulled out (this is how I bought the...
View ArticleNOTICE - Practical Machinist down Mon. May 16 for 24 hours for forum software...
==========================
View Article