New to Mazak tool set up and I need to find the correct tool holders for my Quick Turn 100.
I need to hold a center drill and a .136 diameter drill for piloting an 8-32 Tapped Hole.
I have plenty of drill mount blocks. Do I use these with a proper sized drill bushing or is there another drill block with a collet system that I use?
If I use a drill bushing to the proper size, where is a good source for these? In the meantime, I'll continue searching old threads and on the internet.
Thank you in advance!
I need to hold a center drill and a .136 diameter drill for piloting an 8-32 Tapped Hole.
I have plenty of drill mount blocks. Do I use these with a proper sized drill bushing or is there another drill block with a collet system that I use?
If I use a drill bushing to the proper size, where is a good source for these? In the meantime, I'll continue searching old threads and on the internet.
Thank you in advance!