Hello all,
I ran across a program example a while back where the tool cut a slot with a ball endmill & radius at the top of the slot with a g17 code (if memory serves me). I also remember it looping. It was to cut a 2.5 d shape in a single linear motion. Meaning stepping over in x or y. If you have it I would greatly appreciate either a post or PM me. If you need a pic of what i'm asking for I'll see if i can draw it up tomorrow.
Best Regards
I ran across a program example a while back where the tool cut a slot with a ball endmill & radius at the top of the slot with a g17 code (if memory serves me). I also remember it looping. It was to cut a 2.5 d shape in a single linear motion. Meaning stepping over in x or y. If you have it I would greatly appreciate either a post or PM me. If you need a pic of what i'm asking for I'll see if i can draw it up tomorrow.
Best Regards