Howdy fellas,
We've got a 1980s Mazak QT-10 with a T2 control in the shop, and I'm stumped.
For the last couple weeks, when I try to power the machine up, I can't get any response from the control. The red O and Green | both stay lit. Everything appears to power up fine, I just can't get the machine to do anything. No error codes. :confused:
For a bit of background, for the months, the machine worked. No issues. Then the power went down, and we couldn't get it to restart. We have a backup (CMT I/O) of the parameters, so we tested all the batteries, power supply, capacitors, and double-checked the switches, everything is good. Servo drive has the correct lights, no weird LED codes. Talked to Mitsubishi, they said we should reinitialize the control. Followed the procedure to a T, got everything reset, reloaded the parameters, and now we're stuck with this unresponsive machine.
I have no idea where to go from here. Any chance you have some insight?
Thanks!
We've got a 1980s Mazak QT-10 with a T2 control in the shop, and I'm stumped.
For the last couple weeks, when I try to power the machine up, I can't get any response from the control. The red O and Green | both stay lit. Everything appears to power up fine, I just can't get the machine to do anything. No error codes. :confused:
For a bit of background, for the months, the machine worked. No issues. Then the power went down, and we couldn't get it to restart. We have a backup (CMT I/O) of the parameters, so we tested all the batteries, power supply, capacitors, and double-checked the switches, everything is good. Servo drive has the correct lights, no weird LED codes. Talked to Mitsubishi, they said we should reinitialize the control. Followed the procedure to a T, got everything reset, reloaded the parameters, and now we're stuck with this unresponsive machine.
I have no idea where to go from here. Any chance you have some insight?
Thanks!