Ok I have done some adjustments in TPC but not this extensive. Lathe is a nexus 100 with about 12in of Z travel. I am trying to part some tube off that is around 10in long.
I have a MNP coming up for a stop to pull the material out then going to a grove out to part it off then another groove out to clean up and put a small radius on the tube still chucked up.
I cant get it to run because it hits the soft limit in Z for tool change position, If I could get past this alarm it could pretty much tool change anywhere in Z long as X is in home position.
How do I adjust this? Thanks for any help!
I have a MNP coming up for a stop to pull the material out then going to a grove out to part it off then another groove out to clean up and put a small radius on the tube still chucked up.
I cant get it to run because it hits the soft limit in Z for tool change position, If I could get past this alarm it could pretty much tool change anywhere in Z long as X is in home position.
How do I adjust this? Thanks for any help!