The manual only describes about 75% of the parameters.
It has to be some kind of service manual out there including all of them.
Ringt now I am inerested in OP15.
My ST30ATC has 16 toolpockets + a spare magazine of 32 positions that is not in use.
We do the toolchanges manualy when needed and I have extended that number of preset tools to 64.
So right now we have about 40 preseted tools that we very quickly can install in the machine when needed.
So if we take out tool 10 from pocket 2 and put in tool 38 we go to tool setup and set tool 10 to pocket 0 and tool 38 to pocket 2. (No tooleye or toolpreparation needed)
I want this function in my QT10ATC aswell and have figured out that if I change OP15 from 0000 0000 to 0000 0010 I get this function and I can see and change the toolpockets which was not visible before. But I get an alarm for parameter error so I would like to see the discription of OP15.
It has to be some kind of service manual out there including all of them.
Ringt now I am inerested in OP15.
My ST30ATC has 16 toolpockets + a spare magazine of 32 positions that is not in use.
We do the toolchanges manualy when needed and I have extended that number of preset tools to 64.
So right now we have about 40 preseted tools that we very quickly can install in the machine when needed.
So if we take out tool 10 from pocket 2 and put in tool 38 we go to tool setup and set tool 10 to pocket 0 and tool 38 to pocket 2. (No tooleye or toolpreparation needed)
I want this function in my QT10ATC aswell and have figured out that if I change OP15 from 0000 0000 to 0000 0010 I get this function and I can see and change the toolpockets which was not visible before. But I get an alarm for parameter error so I would like to see the discription of OP15.
