Hi folks.
Another controller question for the above mentioned machine.
Trying to back up my programs (and tool offsets, etc). I've done it before, but by sheer luck and can not make it happen again to save my life.
My process is:
Hit Data I/O. Select "USB". Select NC--> USB/save. Select all <enter> (Left side populates with my progs and I can do that with parameters/tools, etc below)
When I hit "start", I get "557 Designated Directory Not Found". If I select "USB Drive Select", I see [D:\] and [E:\]. Selecting either does nothing. Same error as above.
Anybody spot my error? Many thanks in advance!
Mark
Another controller question for the above mentioned machine.
Trying to back up my programs (and tool offsets, etc). I've done it before, but by sheer luck and can not make it happen again to save my life.
My process is:
Hit Data I/O. Select "USB". Select NC--> USB/save. Select all <enter> (Left side populates with my progs and I can do that with parameters/tools, etc below)
When I hit "start", I get "557 Designated Directory Not Found". If I select "USB Drive Select", I see [D:\] and [E:\]. Selecting either does nothing. Same error as above.
Anybody spot my error? Many thanks in advance!
Mark