G'day all,
Just getting back onto the VQC and I get the servo lag error on all axis. If I try and zero it trips out straight away if I do it manually slowly the numbers move but the axis doesn't so i'm sure it must be a board or something causing it. I have changed out a few of the boards but always the same. I have no errors anywhere on the drives or the boards and parameters freshly loaded a couple of times.
Any ideas???
Just getting back onto the VQC and I get the servo lag error on all axis. If I try and zero it trips out straight away if I do it manually slowly the numbers move but the axis doesn't so i'm sure it must be a board or something causing it. I have changed out a few of the boards but always the same. I have no errors anywhere on the drives or the boards and parameters freshly loaded a couple of times.
Any ideas???