I am trying to figure out how to probe G54 using a Mazatrol program so I can use the G54 in an EIA program. When I add the probing to the Mazatrol program it looks like this:
WPC-0 Add. WPC X Y th Z 4
I know to probe Mazatrol WPC I need to fill out the XYZ locations close so it can probe, that all works fine. However, when I tab over to Add. WPC, the soft keys show G54-G59 (plus additional letters) but when I pick G54, it zeros out the XYZ values, and then when I move over to the XYZ values, it clears the G54 from Add. WPC.
Can someone please shed some light on how this is supposed to work?
WPC-0 Add. WPC X Y th Z 4
I know to probe Mazatrol WPC I need to fill out the XYZ locations close so it can probe, that all works fine. However, when I tab over to Add. WPC, the soft keys show G54-G59 (plus additional letters) but when I pick G54, it zeros out the XYZ values, and then when I move over to the XYZ values, it clears the G54 from Add. WPC.
Can someone please shed some light on how this is supposed to work?