I bought a qt8 Mazatrol T2 and got it home. It has been in storage some time and the batteries have died. This corrupted the parameters and data. I recorded the parameters such as they were,and performed the re-init from service bulletin 0989-002. The electrical manual for this machine was not with the machine. So I do not have the parameters.The machine behaves much better after the re-init. I have two hard alarms 20,and 204 spindle controller. I found a post on here about the power supply dying on the spindle drive. I believe mine has died,there were no leds lit. I checked the ac voltage to the drive it was 230v and there is 230v at the power supply input connection as well.I removed the power supply and powered it on the bench out of circuit. The yellow led lights for a second then goes out. I have electronics equipment and I will try and diagnose the power supply. I called mazak on the parameters,the tech was helpful,and hopeful. He said someone at the factory can get me those parameters for a minimum charge of $500.00 I got a box full of books with the lathe,some of them are for other machines. I have elect manuals for qt35,and qt10n but I dont think I can use the parameters for those,something rather important is going to be different. I have some more reading to do tonight in the parameters manual,but I know some of the guys on here have been here and done this. Any help you can give I thank you.
↧