Couple of questions on how to setup the milling heads in the tool data page on T32-3 control. Just trying to mill some flats in a rod similar to my earlier post. First off is this possible with the 90 degree head with only C axis? I am not sure what best practices are for this type of process. I need the tail stock for support. If it can be achieved is the X0 set at the tip of the end mill to the center line of the part? So basically i am looking for a quick explanation on inputting information in the tool data page. I am setting up tool 16 with a 5/8 end mill and it is the 90 degree head. I am not sure how the tool length is set.
↧