Our little QT15 is kicking my tail pretty good. I just did a LCD swap in a QT15N and was getting the orange screen of doom on the QT15 so I took the old weak monitor out of the 15N and put it into the 15 but get the same orange screen issue. The hydraulics dont fire up either, no light in the work area and the panel doesnt light up. The previous monitor was popping and arcing into the cabinet. But I dont think it was bad it may just have been the ground strap that went around the backside of the monitor. The hydraulics not coming up and the orange screen leads me to believe we have a power issue BUT power is 208 and we set the T-former to 210. I did add about 1.5 gallons of Vactra 25 to the reservior to get it in the sight glass. Still the issues remain.
Oh and Mazak thanks for the bracket change between identicle monitors...that was fun.
So I am going to
1. Check power to the hydraulic motor
2. Was it the FX701 board that was video?
Oh and Mazak thanks for the bracket change between identicle monitors...that was fun.
So I am going to
1. Check power to the hydraulic motor
2. Was it the FX701 board that was video?