Mazak - rebirth (starter pack)

Hello,

After long problems with the inverter, I finally started my QT15N T32-2. I have a few questions for people who know these machines. I had contact with newer markers at work (Matrix, Smooth) and I don't know if I understand everything exactly.

1. The first and most important question is part of the Tool Eye. While I measure the tool, the turret does not stop after pressing the tool eye button (I have to release the button myself) I am afraid to hold longer because I will break the tool eye head :( . The tool changes its dimensions after "beeb" (it looks like it works well) I also can't move the tool away from the tool eye after the measurement. Sometimes error 126 (bad tool eye signal) pops up.

Other questions:

2.Do I have to exchange the EPROM to change the language to English? (unfortunately it is currently German)

3.Is there a way to slow down "rapid feeds" parameter?

4.I heard about changing the spindle acceleration to increase its service life, is that true? :willy_nilly:

5.What hydraulic oil and lube should I use?


I would be grateful for every tip what I could do to make this machine serve me for some time. ;)

Thanks, and please don't "eat" me :stirthepot:

Greetings,
Sebastian

Attached Thumbnails