quick recap from my other thread. bought this lathe in non working order. no parameters,bad control, etc. all that is fixed and mostly operational. I'm down to one 218 chuck alarm from the reinitialization. My chuck will NOT open or close to be able to correct this. another issue is my tailstock. I tried to see if it worked the other day. it did....it came out just fine. now it wont go back in. lol. My relay is clicking on in the cabinet but nothing is going on. I switched relays and got nothing. where are the solenoids located for this? or what else would cause it not to retract? I've never ran this machine yet, but to my understanding the quill retract light has to be on for the spindle to operate ,correct? all i can get it to do is flash,and not retract. does this also apply to the chuck not clamping?i can get the spindle to jog somewhat. and reverse.
↧