I recently had to reinitialize my T2 controller, and after a mountain of headaches, I am finally cutting chips. The issue I'm having with it all is my grooving tool. Whenever I try to use it it wants to cut under center and back up to zero. If I use my OD turning tool it's fine. If I even try to use my grooving tool to face it does the same, so I know I have something jacked up. Could anyone use their electrical hammer and hit me in the head to enlighten me on what I'm doing? It's set up as an OD grooving tool, and it is set correctly as far as the x axis goes( goes to zero correctly). I'm open to ugly comments as long as I can get this running......
↧