Hello all,
Now with the machine finally up and running, I got a job where I have to turn some 8.250 diameter stock. However, when I try to go out to that diameter, and I get to around 6.5 inches diameter readout on the control with my turning tool loaded and set correctly, It gives me a stroke limit alarm? Can this be bypassed in some way? In the manual it says this is set by parameter B1, but what can I change there if anything? I dont want to mess anything up! The max turning diameter for the machine was listed right at 10 inches if I remember correctly, So I am sure I can somehow cut that diameter... What do I need to do to cut these parts?
Thanks for any help!
Nick
Now with the machine finally up and running, I got a job where I have to turn some 8.250 diameter stock. However, when I try to go out to that diameter, and I get to around 6.5 inches diameter readout on the control with my turning tool loaded and set correctly, It gives me a stroke limit alarm? Can this be bypassed in some way? In the manual it says this is set by parameter B1, but what can I change there if anything? I dont want to mess anything up! The max turning diameter for the machine was listed right at 10 inches if I remember correctly, So I am sure I can somehow cut that diameter... What do I need to do to cut these parts?
Thanks for any help!
Nick