Hello.
I have this old H400 with M2 control, wich i bought about two years ago, and after some issues with a bad circuit board
and the wiring harness to the table, it now appears to be running fine.
This is my first contact with mazatrol, and although it is different from the g-code i am used to and has been frustrating at times,
i have come to like it, and i want to learn how to use it as it is pretty quick when writing some programs at the machine.
But now i have a problem with this one thing that i cant seem to find in the books.
When milling along either side or on a line sofar i can only make it do a rough pass and then a finish pass
no matter what numbers i put in for total depht or depht of cut.
My service guy belived that it might have to do with wich surface number you enter (1-9) and i have tried that
but when i enter say 1 or 2 it also skips the finish pass, taking the full depth in one pass.
Surely i am missing something here??
I have this old H400 with M2 control, wich i bought about two years ago, and after some issues with a bad circuit board
and the wiring harness to the table, it now appears to be running fine.
This is my first contact with mazatrol, and although it is different from the g-code i am used to and has been frustrating at times,
i have come to like it, and i want to learn how to use it as it is pretty quick when writing some programs at the machine.
But now i have a problem with this one thing that i cant seem to find in the books.
When milling along either side or on a line sofar i can only make it do a rough pass and then a finish pass
no matter what numbers i put in for total depht or depht of cut.
My service guy belived that it might have to do with wich surface number you enter (1-9) and i have tried that
but when i enter say 1 or 2 it also skips the finish pass, taking the full depth in one pass.
Surely i am missing something here??
