I would like to put an independent 4 jaw chuck on this lathe for low quantity work and holding special fixtures.
Do I have to do anything special with the air circuit from the Howa chuck so that the machine won't error out?
Also, any advice on an 8" 4 jaw chuck to mount on the A1-6 spindle? Is there anything available that doesn't require an adapter plate? I know its tough with the hole pattern. I haven't found anything yet.
Thanks,
Tony
Do I have to do anything special with the air circuit from the Howa chuck so that the machine won't error out?
Also, any advice on an 8" 4 jaw chuck to mount on the A1-6 spindle? Is there anything available that doesn't require an adapter plate? I know its tough with the hole pattern. I haven't found anything yet.
Thanks,
Tony