We have a SQT 200MSY T plus control.
Had to have Mitsubishi rebuild the QX084 board. They had the board for about a week. Got it back and reinstalled. Powered up machine and it would not go past the initial screen say T plus. Called Mazak and Mitsubishi both said have to reinitialize. Got that done and parameters reloaded from EEPROM. Machine homed out fine and all spindles worked fine. Tried to touch off a tool on the tool eye and nothing. When i push soft key MSR UNIT ON the tool eye came down and that soft key was high lighted, but i could not move the turret. I could not even change the mode I was in when tool eye came down (in x100 when tool eye down could not change to x10). Then i thought I would just touch off without tool eye to get machine runnning. Turned MSR UNIT OFF. Tool eye went back up but still not able to change mode. I tried all of them auto mdi rapid jog would not change. Cycle the power and homed fine and can run parts. I did see an old post on here talking about a hidden macro program for the tool probe. We have another T plus machine I can look at if I knew where to look for this hidden program or compare parameters if that could be whats wrong. Any ideas would be appreciated.
Thanks
Had to have Mitsubishi rebuild the QX084 board. They had the board for about a week. Got it back and reinstalled. Powered up machine and it would not go past the initial screen say T plus. Called Mazak and Mitsubishi both said have to reinitialize. Got that done and parameters reloaded from EEPROM. Machine homed out fine and all spindles worked fine. Tried to touch off a tool on the tool eye and nothing. When i push soft key MSR UNIT ON the tool eye came down and that soft key was high lighted, but i could not move the turret. I could not even change the mode I was in when tool eye came down (in x100 when tool eye down could not change to x10). Then i thought I would just touch off without tool eye to get machine runnning. Turned MSR UNIT OFF. Tool eye went back up but still not able to change mode. I tried all of them auto mdi rapid jog would not change. Cycle the power and homed fine and can run parts. I did see an old post on here talking about a hidden macro program for the tool probe. We have another T plus machine I can look at if I knew where to look for this hidden program or compare parameters if that could be whats wrong. Any ideas would be appreciated.
Thanks