Calibrating tool eye for ID tools. (T+)

When I got my QT-6T, I noticed the tool eye was setting all tools about .005" off. I calibrated the tool eye using the fantastic instructions posted here. I'm running T+, so the parameter for that was B63. Those instructions were simple and worked perfectly. Setting OD tools has been rock solid ever since. The problem is that my ID tools are still .005" off and I'm getting tired of manually adjusting the offset on all ID tools. Is there a similar set of instructions for calibrating the eye for ID tools? That parameter would be B61 (Tool nose measurement sensor width in X axis
direction). I would love to just touch off an ID tool after an insert change and be good to go... Thanks!