Fusion 640M Position display

In Mazatrol programs, I'm setting my WPC offsets in the WPC unit.

The position display shows position based on whatever offsets are set in the G54 work offset. If the G54 offsets are all zeros, the position display reads the same as the machine position.

When I cycle start my mazatrol program, the position display reads correctly based on the WPC offsets in the WPC unit in the mazatrol program. If I hit reset, the display snaps back to G54 offsets.

How can I make the position display always show correctly based on the WPC offsets in the active mazatrol program? I'm assuming a parameter, but I'll be damned if I can find it.

Thanks