Hi All,
I have Mazak AJV 18 that was disconnected for over 4 months and we just powered it back up and installed new batteries
we followed the procedure from http://www2.i-logic.com/manuals/Maza...0Procedure.pdf and we were able to do up to step 3 and now it wont let me go past that point..
the fault code says "An error(s) is included in the machine parameter settings for the servo system."
I have attached the images of what I see at the moment if that helps
Thanks
Dan
![Click image for larger version.
Name: IMG_4664.jpg
Views: 13
Size: 99.4 KB
ID: 182219]()
![Click image for larger version.
Name: IMG_4665.jpg
Views: 15
Size: 97.3 KB
ID: 182220]()
![Click image for larger version.
Name: IMG_4658.jpg
Views: 13
Size: 95.1 KB
ID: 182221]()
I have Mazak AJV 18 that was disconnected for over 4 months and we just powered it back up and installed new batteries
we followed the procedure from http://www2.i-logic.com/manuals/Maza...0Procedure.pdf and we were able to do up to step 3 and now it wont let me go past that point..
the fault code says "An error(s) is included in the machine parameter settings for the servo system."
I have attached the images of what I see at the moment if that helps
Thanks
Dan
