Mazak quick turn 8 SP

I just recently acquired my first cnc machine a very clean 1986 Mazak QT 8 SP
the machine set for 6 years without power so it lost memory, I have replaced the batteries
and started entering parameters until i discovered that i was missing the "D" parameters
as well as any hidden parameters. its very exciting because the more info i feed it the more it comes back to
life. I called mazak and am willing to pay them for the parameters, but they are in no hurry to act....I dont have the patients
to wait 2 weeks.

If someone could supply the parameters i would gladly paypal them a few $ for helping out.

Also if there are any independent service techs on this forum in the california bay area that know this machine and are willing to work on it to help bring it back up into good working order please contact me at whri@att.net or (925) 383-1276

just a note on my machine there is no sub spindle, or for that matter there is no tailstock at all so maybe the parameters for a normal quick turn 8 would work?

thanks in advance for any help

Greg Westbury