Was hoping someone might be able to take a quick look at this attempt to single point threads on the backside of a part and let me know what I am doing wrong. Tried all types of scenarios with no luck. I keep getting a 740 illegal angle in first sequence error.
Mazak QTN-100 Nexus Matrix fusion control.
Basically I am turning a shaft .250" with a .375" shoulder and 12-24 threads behind it. Trying to get it all in one work holding. Please ignore how long the threaded area is. It will only be .225" long and the story behind that was clearing it out trying to understand what I was doing wrong in the control.
I was wondering if I should try doing it without the "Back" Option using "out"?
![]()
![]()
Mazak QTN-100 Nexus Matrix fusion control.
Basically I am turning a shaft .250" with a .375" shoulder and 12-24 threads behind it. Trying to get it all in one work holding. Please ignore how long the threaded area is. It will only be .225" long and the story behind that was clearing it out trying to understand what I was doing wrong in the control.
I was wondering if I should try doing it without the "Back" Option using "out"?
