SQT-10m with T-Plus control. I have a part here that I have put a 1 1/32" hole about 2" into the part. When I do side 2 I need to drill a 1 5/16" hole to meet up with the 1 1/32 from the other side. Now I know someone will asked why I don't put both holes in from the same side. For various reasons right now I can't but the main reason is I don't have a 1.032" drill long enough. My question is how do I define that hole from the other side. The problem I'm having is that the holes are put in from both ends but I need to go in with a boring bar and profile the shape using both bores. Right now it thinks that 1.032" bore is solid. I had did this part before and I did put both bores in from the same side but I was having chip problems because I couldn't drill deep enough and so that's why I did it from the opposite so it would become a through hole. If I do these parts again I probably pick up a spade drill. But for now this is what I have to work with. I tried to define the shape with the MTR function but I have never used that before and I had no luck.
Some input would be greatly appreciated.
Thanks Guys!
Some input would be greatly appreciated.
Thanks Guys!