Hi folks!
After spending a career in front of Fanuc based machines, I am now tasked with learning the Mazak. I have a few questions and will break them up into separate entries here. First off, the machine is a VTC250D/50 and the controller is a Mazatrol Matrix Nexus 2. I attended Mazaks school in Cincinatti, but it was very very superficial. My first question is how do I activate the parts counter in EIA mode? I found it in the Mazatrol mode, but not in G-code. Also, how do I reset the parts counter?
Many thanks!
Mark
After spending a career in front of Fanuc based machines, I am now tasked with learning the Mazak. I have a few questions and will break them up into separate entries here. First off, the machine is a VTC250D/50 and the controller is a Mazatrol Matrix Nexus 2. I attended Mazaks school in Cincinatti, but it was very very superficial. My first question is how do I activate the parts counter in EIA mode? I found it in the Mazatrol mode, but not in G-code. Also, how do I reset the parts counter?
Many thanks!
Mark