Hi Folks.
I can use my spindle probe to find WPC's, but not G54, etc. I call up a Maz program, find my X, Y, and Z, write down the numbers, then physically input them into a G54. Thinking there has to be an easier way.
Additionally, is there a way to probe a bore, a boss, a slot, or a web either in Maz or EIA without using "measure" and physically inputting numbers? I've done it with a Haas, but not the Maz (yet).
And while we're at it, can we discuss how to insert a probing program into my EIA and Maz programs? I've got experience doing that with a Haas, but the Maz is a hole new animal. Say I want to probe the center of a hole (or a boss) each time before running the program.
Many thanks!
Mark
I can use my spindle probe to find WPC's, but not G54, etc. I call up a Maz program, find my X, Y, and Z, write down the numbers, then physically input them into a G54. Thinking there has to be an easier way.
Additionally, is there a way to probe a bore, a boss, a slot, or a web either in Maz or EIA without using "measure" and physically inputting numbers? I've done it with a Haas, but not the Maz (yet).
And while we're at it, can we discuss how to insert a probing program into my EIA and Maz programs? I've got experience doing that with a Haas, but the Maz is a hole new animal. Say I want to probe the center of a hole (or a boss) each time before running the program.
Many thanks!
Mark