Hey guys,
I'm decent with conversational on lathes. I've programmed by hand my entire career both g code and conversational. We recently acquired a mill, vcn530c, and I'm learning the programming quickly. But the part I'm making has a feature that I'm not sure I can program using conversational. At least I've tried and cant seem to figure it out yet.
I need to make a .75 dia. pocket, .058 deep, with a 1.25 radius in Z, and I want to do it with a ball em.
Ideas?
I'm decent with conversational on lathes. I've programmed by hand my entire career both g code and conversational. We recently acquired a mill, vcn530c, and I'm learning the programming quickly. But the part I'm making has a feature that I'm not sure I can program using conversational. At least I've tried and cant seem to figure it out yet.
I need to make a .75 dia. pocket, .058 deep, with a 1.25 radius in Z, and I want to do it with a ball em.
Ideas?