Hi All,
I'm new to Mazak lathes, and trying to get my first program running on a QT15N that has a T32-2 control. I'm just getting the lathe going. The seller said that he had just replaced the batteries, and downloaded the parameters.
I have the Mazatrol program written, and put the tool information into the Tool Data (1), (2), and Tool Offset pages. It is my understanding that Mazatrol programs only use the Tool Data pages, and EIA only uses the Tool Offset pages.
When I go to the Tool Path page, the Shape softkey shows the shape properly, but when I press the Check Continue softkey, I get the error 814 Unfinished Tool Set. From what I can see, I have all the tool information for Tool 8 entered. I don't see what I'm missing.
I've searched the forum and seen some other threads with people who had a similar problem. In those threads the problem seemed to resolve itself without the poster knowing what was done to fix the issue.
Can anyone see any missing information in my setup?
I'm new to Mazak lathes, and trying to get my first program running on a QT15N that has a T32-2 control. I'm just getting the lathe going. The seller said that he had just replaced the batteries, and downloaded the parameters.
I have the Mazatrol program written, and put the tool information into the Tool Data (1), (2), and Tool Offset pages. It is my understanding that Mazatrol programs only use the Tool Data pages, and EIA only uses the Tool Offset pages.
When I go to the Tool Path page, the Shape softkey shows the shape properly, but when I press the Check Continue softkey, I get the error 814 Unfinished Tool Set. From what I can see, I have all the tool information for Tool 8 entered. I don't see what I'm missing.
I've searched the forum and seen some other threads with people who had a similar problem. In those threads the problem seemed to resolve itself without the poster knowing what was done to fix the issue.
Can anyone see any missing information in my setup?