Mazak with M32 control VMC won't read height offset in EIA NEED HELP

I am working on a MAZAK MTV 414/22 with a M32b control. Batteries went deat. Loaded the parameters from EPROM, Changed F93,ect all four the page says reading the bits from right to left with the furthest right being 0. The machine runs the first tool fine, changes tool and when it reaches the G43 line it goes straight up in Z. I am at a loss and mazak says they don't know either. Has anyone had this problem? I was going to write in the offsets using g10 but this machine doesn't read them correctly or I am not inputting them in correctly. I will say if I change the H offset on the second tool to the same as the first one the program runs fine it just seems to only run the tool that I "teach"ed the G54 with. Let me know if anybody can help

Chris