Hello, I have a 1984 Mazak V5
24 ATC with Fanuc 6M control
Machine has been a work horse for my shop for over a year.
However recently I've been getting a red light display under spindle and machine malfunction, no alarm codes but it turns the spindle off.
I press machine "on" beside the display and it restarts but only for a short time.
I know the Mazaks are sensitive with oil levels. The spindle requires DTE Lite24.
Im faithful with changing and topping fluids on the work center.
Sometimes I can get through 5 short (4min) cycle times until it alarms out again.
Any thoughts on what the problem could be??
24 ATC with Fanuc 6M control
Machine has been a work horse for my shop for over a year.
However recently I've been getting a red light display under spindle and machine malfunction, no alarm codes but it turns the spindle off.
I press machine "on" beside the display and it restarts but only for a short time.
I know the Mazaks are sensitive with oil levels. The spindle requires DTE Lite24.
Im faithful with changing and topping fluids on the work center.
Sometimes I can get through 5 short (4min) cycle times until it alarms out again.
Any thoughts on what the problem could be??