The machine is an Integerx IV with Matrix control.
When the main spindle is at C0. the home light is not on. When commanded to G28H0. the home light comes on but the position displayed is 90.1563. So G28 home and C0 are not the same position. All offsets are zeroed out. This does not seem correct to me.
On another note the sub-spindle shows 209 degrees when it is sent to G28H0.
I have not seen this on any other lathe. Is this correct?
Thanks
When the main spindle is at C0. the home light is not on. When commanded to G28H0. the home light comes on but the position displayed is 90.1563. So G28 home and C0 are not the same position. All offsets are zeroed out. This does not seem correct to me.
On another note the sub-spindle shows 209 degrees when it is sent to G28H0.
I have not seen this on any other lathe. Is this correct?
Thanks