Well after all the other problems I had with the VQC20/50b I had it running properly for a little while. Yesterday I wrote a simple program and when I went to run it it picked the required tool then just sat there doing nothing. I thought I must have missed something or maybe the heat of the day. I couldn't find any probs with the program so shut it down and went and had a few beers to let us both cool down:D. Went out this morning and tried it again. Still the same:mad5:. I tried running programs that I had run in the last week and they all did the same thing. I changed the FX784/8 then the FX715 boards with known good ones. Still the same. I can run the spindle manually no probs but it seems like the spindle drive does not get the start command when in auto. I have no alarms come up and no error LED's on any board or controller. I'm getting so over this machine at the moment. Any ideas?????:crazy::crazy::crazy:
↧