Hi All,
I am wondering if any of you smart folks can help me find a way to do this. Attached is a picture of part geometry and a rough looking tool for a part I am about to make. I would like to use a tool to bore the diameter and taper on the back side of the shoulder. This direction I only have about 1 inch of hang out to help achieve a critical surface finish on this surface. From the other direction I will be hanging out almost 2 inches with a par diameter of less than 3/8".
Any help with an approach to tool description and how to program a unit for this would be a great help! I am a mazak veteran of 11 years but have never had a requirement for this kind of approach. I am using a QT100 with collet chuck, Matrix Nexus controller.
Thanks,
Snider![Click image for larger version.
Name: back bore.jpg
Views: 1
Size: 14.0 KB
ID: 214555]()
I am wondering if any of you smart folks can help me find a way to do this. Attached is a picture of part geometry and a rough looking tool for a part I am about to make. I would like to use a tool to bore the diameter and taper on the back side of the shoulder. This direction I only have about 1 inch of hang out to help achieve a critical surface finish on this surface. From the other direction I will be hanging out almost 2 inches with a par diameter of less than 3/8".
Any help with an approach to tool description and how to program a unit for this would be a great help! I am a mazak veteran of 11 years but have never had a requirement for this kind of approach. I am using a QT100 with collet chuck, Matrix Nexus controller.
Thanks,
Snider
