Integrex J-300 manual program question

I am trying to create and oil groove in a bore. I have done this on our old Integrex but can't get it to work on our J-300. The tool looks like a I.D. groove tool with a full nose radius. The oil groove is a figure 8. I defined it as a boring bar, did an m205 to stop the spindle and a m200 to select mill mode. I can get it to feed in in/min but it barely moves even when I max it out. It will run in rapid but it is a bit fast for the tool. Any help would be appreciated. Here is a video of the program and it running in rapid:

IMG 0020 - YouTube